Trailer Brake Controller Custom Harness for 08-16 Ford F-250/350/450 Super Duty

Description: Trailer Brake Control Harness 3034 A 1. Make sure the vehicle is off with the keys removed from the ignition. 2. Locate access panel in the center of dash on passenger side. Using a trim panel puller, locate notch in panel and pry the panel out and away from the dash being careful not to damage the trim or panel. Unplug the housings attaching the panel being careful not to damage locking tabs and set aside. 3. On vehicles equipped with factory brake controller locate the large grey housing matching the mating half of the adapters connector. Housing will be plugged into the back of the unit. Additional harnesses may need to be unplugged to gain access to its location. NOTE:When disconnecting the factory installed brake control, you will get a fault code displayed on the message center of the dash. 4. On vehicles without a factory brake control locate grey housing on the back of the trim panel located directly left of the access panel. 5. Carefully pull the housing towards the access panel and plug in the mating grey housing from the brake control adapter. 6. Locate a routing path for the adapter to exit the bottom of dash. TIP:Use a flash light to shine light up though the bottom of dash to locate a hole to exit the dash. 7. Complete the installation per the electric brake control manufacturer’s instructions and mount the unit as directed. Perform test procedures as instructed. 8. After brake controller is installed, plug in all connectors that were not used back into the original housings and snap access panel back into place. NOTE: Vehicles not equipped with OEM trailer tow package, may require fuses and relays to complete output and battery feed circuits (sold separately). Our units are designed for brake controls manufactured with electrical wiring mounted on the back of the unit, otherwise known as a pigtail. Wiring harnesses must be spliced into the existing pigtail to allow the vehicle specific plug to be installed. ******************* CUSTOM DESIGN: Tekonsha trailer brake controller harnesses are designed to make connecting your brake controller to your vehicle quick and easy. These harnesses fit into any Tekonsha brake controller with a Plug & Play port. The other end fits into the factory plug in your vehicle. EASY INSTALLATION: Tekonsha’s Plug & Play design lets you use the wiring harness to easily connect your brake controller to your vehicle, no cutting, splicing, or taping required. Simply follow the detailed vehicle specific instructions included with your product to install. PROTECTED WIRING: The four copper wires in each harness are covered with a braided mesh to give a factory-installed look. The covering also provides protection from damage like nicks and punctures, keeping the harness wires safe from elevated temperatures and potential shorts. VERSATILE: This brake controller wiring kit works with every activation type whether it be proportional or time-based brake controllers in the Tekonsha line. APPLICATIONS: This Tekonsha brake controller harness fits the following make and model year vehicles: 2009-2014 Ford E-150 Econoline, 2009-2014 Ford E-250 Econoline, 2009-2014 Ford E-350 Econoline Super Duty, w/Factory Tow Prep Plug2009-2011 Ford E-450 Econoline Super Duty, w/Factory Tow Prep Plug2013-2014 Ford Expedition, 2008-2016 Ford F-250 Super Duty, 2008-2016 Ford F-350 Super Duty, 2008-2016 Ford F-450 Super Duty, 2008-2016 Ford F-550 Super Duty, 2013-2014 Lincoln Navigator.

Price: 19.9 USD

Location: Fayetteville, North Carolina

End Time: 2024-11-30T21:37:55.000Z

Shipping Cost: 0 USD