Description: KEEP CORDS SAFE: The Dumble RV Supplies | 30 Amp Locking Connector with Cover Boot and Ring is designed to secure and protect your cord connector and keep a weatherproof seal for your RV, camper, trailer, marine watercraft, and other outdoor applications; For regulating and waterproofing purposesUSE YOUR CONNECTOR: Quickly locks the cord set in the inlet; Side grips for an easy and secure connection; Designed for use with round jacketed, hard usage cable (S-type), 8-3AWG; As long as you have a female cord connector with the same 30A 125VAC configuration, this connector will fit your applicationPERFECT SIZE: 7.5-inch (19.1cm) assembly overall length; Cover and ring – 1.75-inch (4.4cm) inner diameter (ID); 3-inch (7.6cm) outer diameter (OD); 3-inch (7.6cm) inside depth; 5-inch (12.7cm) outer length; Connector – Approximate measurement across the face is 1.75 inches (4.4cm); Across the back where the cord enters adds 0.25 inch (2 inches / 5.1cm across); Total length is 3.9 inches (9.9cm)BUILT TO LAST: Cover constructed with a bright yellow rubber body and black heavy-duty plastic ring for extra longevity with no leaks; 30 Amp 125 Volt rating; Replace your power cord with this twist lock connector so the cord can be removed and stored without leaving an opening that mice or insects can enter and wreak havocEASY TO USE: Instructions included; Remove housing by loosening face screws, slide weather-resistant boot over cable, and slide housing over cable; Strip cord outer jacket and each individual conductor to expose the copper wire; Insert all wires into proper color-coded terminal pockets; Tighten terminal screws and strain relief screws; Slide housing over connector body, tighten assembly screws, and slide weather-resistant boot over complete assembly Replace the end on your existing power cord with the Dumble RV Supplies 30 Amp Locking Connector with Boot & Ring. It keeps a weatherproof seal for your RV, marine watercraft, and other outdoor applications. The female connector and cover ring are designed for use with round jacketed, hard usage cable (S-type, 8-3 AWG). Remove the housing by loosening the 3 screws on the face of the device, slide the included weather-resistant boot over the cable. Strip the outer jacket of the cord and each individual conductor. Insert all the wires into the proper color-coded terminal pockets. Tighten the terminal screws and strain relief screws. 5-inch cover and 1.75-inch ring diameter fits over 3.9-inch connector with 1.75-inch inlet face for a weather-resistant seal. Warning: This product can expose you to chemicals which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm.
Price: 28.41 USD
Location: Denver, Colorado
End Time: 2025-01-01T20:56:14.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
Restocking Fee: No
Return shipping will be paid by: Seller
All returns accepted: Returns Accepted
Item must be returned within: 30 Days
Refund will be given as: Money Back
Brand: Does not apply
Type: Does not apply
Amperage: 30 Amps
Product Dimensions: 3"D x 3"W x 3.9"H
Plug Type: L5-30R
Connector Type Used on Cable: Plug in
Connector Type: Plug in
Number Of Wires: 3
Voltage: 125 Volts
Number Of Poles: 3
Item Dimensions D x W x H: 3"D x 3"W x 3.9"H
