Keyless remote entry H50T09 alarm starter car keyfob clicker transmitter fob

Description: Installed RKE System Type: Please be sure you have an AFTERMARKET (RKE) remote keyless entry system. If your current remote looks the same then this will work. Other options include: Dealer Installed or Factory. The system installed in your vehicle will CHANGE the required remote. If you are unsure send us a message with your current remotes FCC ID and Part # and LED Light color. If you no longer have your remote then send us a message with your system brand, and system id #. What are you purchasing ? This is ONE (1) replacement keyless entry remote control that will work with your AFTERMARKET installed RKE system. We sell these transmitters in conditions as well. Please check out our store for color / condition / price options. Compatibility: Compatible FCC ID#(s): H50T09 Alternate Spellings H5OT09 H5OTO9 H50 T09, H50T09, H50TO9, HS0T09, H5OTO9 Part #(s) MT-55C or VT-55C MT55C VT55C Button Count: 5 : Lock, Unlock, Trunk, Start/Panic, side; LED Green Battery (installed): 1; GP23A Frequency: 434 MHz LED Light Color: Green Circuit board #s: #s on Chip on board: Condition Notes: NEW Compatible Aftermarket Installed Systems: MT-55C MT55C (Interchangeable Part#) VT-55C VT55C MT-65H MT65H MT-66H MT66H Autopage XT-59 Programming: Please note not all customers will be able to complete the programming on their own so if you are having trouble or unsure diagnostic programming is available at your local qualified automotive locksmith or car/audio shop. Programming:It is important to remember that during programming each individual step of the procedure must be executed within 15 seconds of the previous step. When the 15 seconds time limit is allowed to expire, the system will automatically exit programming mode. This is indicated by a long chirp from the siren. Additionally, any time the ignition key is turn off while programming, the system will immediately exit the programming mode. Or after you learn all the channels, turn valet switch “on/off” the system will exit programming mode, this is also indicated by a long chirp from the siren. 1. Enter the programming mode: First the system should be in disarm condition, set dipswitch no 8 to on position then turn the ignition switch to on/off three times. You will hear one chirp, one flash sequence from the LED, indicating the system is ready to accept programming channel 1 or arm/disarm and panic function. 2. Programing the Transmitter Codes: a) Channel 1 programming (for arm/disarm) Press one of the buttons as you like as button 1 until the alarm gives you a confirmation chirp. You can program up to 4 transmitters in channel 1. b) Channel 2 programming (for trunk release) after programming channel 1 turn the valet switch on/off there will be one chirp and two flash sequences from the LED. Indicating the system is ready to accept programming channel 2. Press btn II to program channel 2. Programing procedure is the same as programming channel 1. c) Channel 3 programming (for channel 3) after programming channel 2. Turn the valet switch on/off there will be one chirp and three flash sequences from the LED. Indicating the system is ready to accept programming channel 3. Press btn III to program channel 3. Programming procedure is the same as programming channel 1. d) Channel 4 programming (for car locator) after programming channel 3. Turn the valet switch on/off there will be one chirp and four flash sequence for the LED indicating the system is ready to accept programming channel 4. Press btn IV to program channel 4. Programming procedure is the same as programming channel 1 Compatibility: Works with vehicles that use a aftermarket keyless entry system listed in my compatibility section above. Why does your vehicles installed RKE / Security system determine which remote control your can purchase? The remotes job is to pair with your vehicles installed RKE system. It will only sync to a matching system; therefore, you cannot purchase a different type of remote than the remote manufactured with the system. It will not pair with a foreign system. Programming Requirement Information NOTE: The vehicle manufacturers determine the programming requirements at the time of manufacture. We pass the programming requirements / instructions on to you as a courtesy when we have them. We do not write the programming nor do we determine which vehicles require diagnostic programming and which vehicles can be programmed by you (DIY). We are neither locksmiths nor mechanics nor are we familiar with EVERY vehicles program sequence. If you have questions: 1. Check your Aftermarket system manual. 2. You Tube has many video postings from do-it-yourselfers to assist with all kinds of questions & most customers find if very helpful to WATCH the programming being done which can eliminate mistakes in the sequence. a. To locate the programming for your vehicle via this method go to You Tube and once there in the search bar type in the following: i. If you have a factory RKE system: your make model year + the words program remote (i.e.: 2005 Ford Mustang program remote) ii. If you have a dealer installed or aftermarket RKE system: the FCC ID or system type + the words program remote (i.e.: ELVAT5C program remote or AS200 program transmitter) 3. For OEM FACTORY installed systems: send us an eBay message with your vehicles make, model, & year = we can pass on to you any programming information requirements we have on hand. 4. For DEALER INSTALLED RKE installed systems: send us an eBay message with your remote controls FCC ID # and PART# and the vehicles make, model, & year = we can pass on to you any programming information requirements we have on hand (the programming for dealer installed RKE systems will be different than Factory or Aftermarket installed RKE systems). 5. For AFTERMARKET INSTALLED RKE installed systems: send us an eBay message with your remote controls FCC ID # and PART# = we can pass on to you any programming information requirements we have on hand (the programming for aftermarket installed RKE systems will be different than Factory or Dealer installed RKE systems). 6. There are also many auto forums that you can go onto by just conducting a google search with your questions. 7. or a local automotive locksmith or your local parts/car/audio store will typically be able to assist you if you are trying to avoid the dealer Normal 0 false false false EN-US X-NONE X-NONE

Price: 52.15 USD

Location: Wellsboro, Pennsylvania

End Time: 2025-01-01T14:14:12.000Z

Shipping Cost: 6.96 USD