Description: P2000 readers modules The S300-DIN-RDR2SA module provides interface control for access and security devices associated with up to two doors. The module connects up to 2 readers via Wiegand Ports or in RS485 with Open Supervised Device Protocol (OSDP) Version 1.1. The RDR2SA provides inputs and outputs for interface and command two doors, supervised inputs for: door status, aux inputs and exit buttons. Two additional inputs are dedicated to power failure and enclosure Tamper status. Any points not used for the door can be configured as general purpose I/O points, possibly eliminating the need to purchase additional I/O modules for certain installations. The RDR2SA provides power for the card reader hardware, and output relays for the doors. The door locking hardware is powered locally. The RDR2SA uses standard RS485 communications and can interface the following controllers: CK722, CK721-A, and the legacy controller: CK721, CK720 and CK705. Please note, the CK721-A using firmware versions earlier than 3.0, CK721 controllers, and CK720/705 controllers are not supported by P2000 Version 3.13 and later. In the RDR2SA, each of the 2 door interfaces consists of: • Wiegand® Data0 and Data1 interface or RS485 OSDP V. 1.1 • Supervised door monitor switch input, normally open or normally closed, based on wired configuration • Supervised auxiliary input • Supervised “request to exit” switch input, normally open • Door strike relay, Single Pole Double Throw (SPDT) • Alarm shunt relay, SPDT • Red lamp driver (open collector) • Green lamp driver (open collector) • +12 VDC 250 mA per reader power supply In addition, each module has the following common inputs: • Calibration resistor input • Supervised power fail input • Supervised panel tamper input To power supply Exit Sensor Door Monitor 2 door module Features Security products P2000 Alarm Reader Strike CK721-A f 2 reader interfaces: 2-wire Wiegand interfaces or two RS485 bus ODSP Version 1.1. f 4 open collectors for readers green and red LED indicators (max 12 VDC / 100 mA) f 8 supervised inputs with calibration f 4 relay (Lock+Shunt) outputs 1 A maximum, 24 VDC, 25 VA maximum f Communication bus to CK controller: RS485 at 9.600 or 19.200 Baud fInput voltage power 12 to 24 VDC or 16 to 24 VAC at 24 W f Power to reader: 12 VDC, 250 mA (typical) f Mounting specifications DIN rail or flat surface f Dimensions (W x H x D): 144 x 150 x 55 mm
Price: 150 USD
Location: Calera, Alabama
End Time: 2024-11-11T04:37:23.000Z
Shipping Cost: N/A USD
Product Images
Item Specifics
All returns accepted: ReturnsNotAccepted
Brand: Johnson Controls
Unit Type: Unit
Model: RDR2SA
Unit Quantity: 2
