Electronic Ignition: 1970-76 Toyota Land Cruiser FJ40, FJ55 (F engine)

Description: Electronic Ignition Conversion Kit 6-cylinder Nippondenso (points-based) Distributors: Toyota, Toyota Industrial, Nippondenso Distributors (for 12-volt, negative ground electrical systems only) The Hot-Spark electronic ignition conversion kit replaces breaker points and condenser in the distributor to provide rock-solid reliability. With the Hot-Spark electronic ignition, dwell and timing are always spot-on accurate. No matter how strong your engine is, you won't get the most out of it without a good spark. The stock, points-based ignition system used technology that dates back a century - to the Kettering system, which was introduced in the 1910 Cadillac. Even though you can adjust breaker points for near-electronic ignition performance, they will burn and wear within a few thousand miles, long before the recommended replacement interval. With points, the timing will drift; power and fuel economy will suffer. The Hot-Spark electronic ignition conversion kit delivers a strong spark every time and is maintenance-free. You'll notice quicker starts, more top end power and a little gas mileage boost. It's as easy to install as points and condenser! Advantages of the Hot-Spark electronic ignition conversion kit: Replaces points and condenser with solid-state electronics Set it and forget it - Never adjust points and timing again! Zero maintenance Delivers far more voltage to the spark plugs than points-based points Reliable Hall-effect technology Never gets out of adjustment Rock-steady reliability Dwell and timing are always spot-on accurate Increased gas mileage, fuel economy Quick starting Smooth idling Cleaner emissions Longer spark plug life Longer engine life Cleaner engine oil due to less unburned fuel Longer interval between oil changes Easy to install - If you can install points, you can install the Hot-Spark electronic ignition conversion No points to wear, burn, pit or corrode No condenser needed Absolutely no points float - zero - even at redline RPM and beyond! Never worry about drifting dwell or timing again No rubbing parts - nothing to wear out! Fits completely under the distributor cap Stealth modification - maintains stock appearance Includes everything you need, no external ignition box required. Works with stock distributor and coil Encased in high-temp thermoplastic - protected from the elements and oil, grease, dirt, water, etc. Never bother with points or condenser again! The best investment you'll ever make for your vehicle Saves precious ($$$) fuel Coil with 3.0 Ohms or more internal, primary resistance required. Bosch Black Coil is ideal for HotSpark ignition kits. Requires a 12-volt, negative ground electrical system. External Ballast Resistor: If the charging system voltage, measured at the coil's + terminal, is more than 13.9 volts at any RPM level, the voltage regulator likely needs replacing or a 1.4 Ohm ballast resistor should be wired between the coil's + terminal and the red HotSpark ignition wire. Too much voltage can damage the ignition module and other electronic components. How many miles until the Hot-Spark electronic ignition conversion kit pays for itself? Click here www.Hot-Spark.com/Coil.htm : Measuring Coil Resistance (and more) HotSpark ignition conversion kits fit only distributors that originally had points and condenser, not electronic ignition. For original equipment Toyota/Nippondenso (with single, right-pivoting points, not dual-points) distributors only. For: 6-cylinder Nippondenso distributor - 3ND6U1 Toyota Toyota Crown with 6-cyl distributor with points and condenser - 3ND6U1 1974-77 6-cyl Landcruiser with Nippondenso Distributor with right-pivoting points, secured by two screws to breaker plate - 3ND6U1 Toyota Industrial All 6-cyl 2FG-50, 2FG-60, 3FG-32, 3FG-35, 3FG-40, 3FG-50, 3FG-60 - 3ND6U1 Nippondenso 6-Cylinder Distributors: Toyota 6-cylinder Industrial Applications: 2FG-50 - 3ND6U1 2FG-60 - 3ND6U1 3FG-32 - 3ND6U1 3FG-35 - 3ND6U1 3FG-40 - 3ND6U1 3FG-50 - 3ND6U1 3FG-60 - 3ND6U1 Nippondenso 6-cylinder Distributors (Toyota): 029100-1231 - 3ND6U1 Toyota Land Cruiser (F engine) 029100-3161 - 3ND6U1 029100-3184 - 3ND6U1 19100-60061 - 3ND6U1 19100-61010 - 3ND6U1 1970-76 Toyota Land Cruiser FJ40, FJ55 (F engine) 19100-61010 - 3ND6U1 1974 (non-California models, with points) Toyota Land Cruiser FJ40, FJ55 (F engine) 19100-61020 - 3ND6U1 2F Distributors The points in your distributor must look exactly like the points in the above photos or the 3ND4U1 or 3ND6U1 ignition kit won't fit your distributor. If your distributor's breaker plate has an upright pivot pin remaining, after you remove the points, this ignition kit won't fit it. The points must be the type that are secured to the breaker plate by two screws. The above-pictured points are 1-piece, right-hand pivot pin points. For original equipment Toyota/Nippondenso points-based distributors only. www.Hot-Spark.com/Installing-Hot-Spark-Nippondenso.pdf International Buyers – Please Note: Import duties, taxes and charges are not included in the item price or shipping charges. These charges are the buyer's responsibility. Please check with your country's customs office to determine what these additional costs will be prior to bidding/buying. VERY IMPORTANT -- BEFORE ORDERING: Some distributors of vehicles, boats, etc. may differ, according to whether the stock distributor is still in place or a replacement distributor has been installed. Some otherwise similar or identical engines use different distributor brands and/or different distributor part numbers. We need your distributor's brand name, distributor part number and number of engine cylinders to ensure that the electronic ignition conversion kit is correct one for your particular distributor. If your distributor part number, normally found on the side of the distributor body, is not among those listed on the relevant web page, chances are, the HotSpark ignition conversion kit won't fit your distributor. It's imperative that we know your distributor's brand name, distributor part number and the number of cylinders of your engine. You may need to remove the distributor temporarily, so that you can read the distributor part number from the side of the distributor body. Usually, the side of your distributor will be covered with oil and dirt, so you'll need to clean it to find the distributor brand name and exact part number. We can guarantee only that each of our ignition kits will fit a distributor with one of the distributor part numbers listed on its relevant web page. Otherwise, it likely won't fit. HotSpark ignition kits require a 12-volt, negative ground (earth) electrical system. If you order the wrong electronic ignition conversion kit for your distributor, you'll need to return it to us, via US Postal Service mail within 30 days from date of purchase. If the ignition kit is in perfect, unused condition, we can accept it as a retuned item, within 30 days of purchase, and provide a refund to your account, less a 20% restocking fee and any international shipping fees, etc., but only if the ignition kit is in pristine, unused condition. Buyer is responsible for shipping and other costs to return the product for credit or exchange. 3ND6U1 Electronic Ignition Conversion Kit for 6-cylinder Nippondenso Distributors with Points and Condenser Easy to Install - Replace Points and Condenser with Solid-State Electronics Hot-Spark Electronic Ignition Conversion Kit for 6-cylinder Nippondenso Distributors with right-pivoting, 1-piece points For Distributors: Nippondenso 6-cylinder distributors with right-pivoting points and condenser (has same ignition module and base plate as 3ND4U1 kit, but with 6-cyl magnet sleeve): 029100-1231 029100-3184 CW 19100-60061 19100-61010 CW Toyota Crown with 6-cyl distributor with points and condenser 1974-77 6-cyl Landcruiser with Nippondenso Distributor with right-pivoting points, secured by two screws to breaker plate If your distributor's breaker plate has an upright pivot pin remaining, after you remove the points, this ignition kit won't fit it. The points must be the type that are secured to the breaker plate by two screws. Application: 6-cylinder Toyota cars, trucks with points distributor Toyota industrial engines 12V negative ground only. Coil Required: Coil must have 3.0 Ohms or more internal primary resistance. In stock: Available: Item Number: 3ND6U1 Price: US $79.95 FREE SHIPPING to anywhere in the USA Item Name: Hot-Spark Electronic Ignition Conversion Kit for 6-cylinder Nippondenso Distributors with right-pivoting points and condenser Includes everything you need - no external ignition 6 box required. Price: US $79.95 Price with Shipping Shipped within USA $79.95 USD Shipped to Other Countries $119.95 USD Foreign Orders: Shipping discount available if purchasing multiple items. Dealer Inquiries welcomed. © 2005-2023 Hot Spark® electronic ignition conversion kit nippondenso distributor Toyota 1641 1665A

Price: 79.95 USD

Location: Austin, Texas

End Time: 2024-02-09T19:44:01.000Z

Shipping Cost: 0 USD