85mm GPS Digital Speedometer Odometer Tripmeter IP67 Car Motorcycle Truck Boat

Description: The speedometer shows Current Speed, Trip Meter(return to 0 after power off), COG, ODO(cannot be reset), Press the back button to adjust unit(KM/H. MPH, KNOTS). Notes: Low speed readings (speeds 3 knots and under) not useful.Function introduction: SOG:speed over water COG:Course Over Ground ODO:Odograph TRIP:Short driving distance mileage,the mileage will be cleared once the power is cut off ODO:Total mileage,the mileage cannot be cleared even if the power is cut off. Features:-Suitable for all vehicles, boats and off-road vehicles.-The signal comes directly from the satellite signal receiver(GPS Speed Sensor)-The gauge has the advantages of high precision, quick location confirmation and short start up time.-IP67 waterproof and dustproof grade.-Stepper motors used for full range of stepping gauges, great feature with its less power consumption, longer life, higher precision, etc.-With curved glass (with anti-fogging function).-With ultra-wide working voltage design( long-term operating voltage: 9-32V, Maximum up to: 36V (≤ 1 min)). WIDELY APPLICATION How to install it?- Cut an 85mm (3 3/8") hole in the panel and allow a clearance of 70mm (2 3/4”) behind the panel to fit the gauge.- Put the gauge in the hole.- Using M4 nut and C type bracket to seal up the gauge.- For the GPS antenna, you should securely fasten it in the flat position, black side upwards, preferably outside (or inside front windscreen) so that it has a clear view of the sky to pick up satellite signal. Connect the antenna cable to socket in the back of the gauge. And do not cut cable.Note:- For the GPS antenna, you should securely fasten it in the flat position, black side upwards, preferably outside (or inside front windscreen) so that it has a clear view of the sky to pick up satellite signal. Connect the antenna cable to socket in the back of the gauge. And do not cut cable.- It takes about 30 seconds to get signal in the first time, but less than 3 seconds after that. It gets quicker under a clear view of the sky. Sometimes if signal is missing, pls. reconnect all wires and restart it. Q&A:1.Why does LCD show E01, E02, E03?- Turn on supply power after installation.- Then the meter starts to search for signal and LCD will count automatically.- If there is still no signal when LCD counts to 300. If there is still no signal, GPS speedometer will be flickering.- If LCD shows E01, It means that there is not any GPS signal after starting working.- If LCD shows E02, It means that GPS speedometer signal was lost during working.- If LCD shows E03, It means that the device failed. 2.GPS Speedometer keeps counting?- After installation in the first time, GPS speedometer needs to search for signal, that's the reason that LCD counts numbers all the time.- After getting signal, LCD will come back to 0. It is normal. Specification Fixing Dimension: 85mm(3-3/8") Unit: MPH/KMH/KNOTS Operating Voltage :9~32VDC Operating current: ≤100mA Working Voltage: 12V/24V Backlight:Red Operation Mode: LCD display, stepper motor Protection Grade:Dustproof and waterproof rating: IP67(The speedometer can works normally in 1 meter underwater ) Material:316 Stainless steel bezel with curved glass Operating temperature:-30~+759℃ Storage temperature :-40~ + 85℃

Price: 54.99 USD

Location: shenzhen

End Time: 2024-08-09T08:21:04.000Z

Shipping Cost: 0 USD