12000Btu/Hr Mini Swimming Pool Heater Work with Water Pressure More than 20Kpa C

Description: Note：Must Work with at Least 0.75HP Circulating Pump,water pressure more than 20kPa.Need 24 hours For Heating Pool.Suitable for pools up to 2000 gallons in coastal climates.the temperature ranged from 40 °F-122 °F (5 °C-50 °C).Material: Metal;Voltage: 220-240V/50-60Hz;Power: 3KW;Current: 14A;Phase Parameters: Single Phase;NOTE:One interface is 50mm, the other port is 32mm, please note the size of the pipe before use.A Better Way to Extend Your Swim Season: Nothing beats a warm swimming pool for your kids, pets and the whole family! What you’ll need is a highly efficient, low operating cost heating system – an AYCHLG pool heat pump for your pool to extend the fun for a few more months!Superb Energy Saver:The pool heater is a heat pump specifically designed for swimming pools. The operation only requires very limited electric input, hence its high efficiency and heat conversion rate can reach a score of COP 84.2.The product is easy to operate, provides a mechanical fit for thermostat switch, you can set the temperature of temperature technologyThe product is small, suitable for: hot tub & swimming pool equipment and it is easy to install in the bathtub at the bottom of the circulating massage pipe Swimming Pool fit for Thermostat 240V Pool fit for Thermostat Heater 3KW Pool SPA Bath Hot Tub Electric Water Heater fit for Thermostat Introduction: Fit for Thermostat is designed specifically for the needs of the Jacuzzi, the fit for thermostat installed in the bottom of the tub on the massage tub, after adding hot water in the bath, start the water pump, the fit for thermostat automatically heating insulation, the bath water temperature maintained at 30-40℃ adjustable, it can give your massage bathtub to create a comfortable environment. Normal Operation: The operation of the fit for thermostat is fully automatic. When installed properly it will turn ON after user have set the temperature by turning the controlling switch clockwise, then the heating-up indicator turns on. As long as the fit for thermostat is on, it will heat up the water to the user-set level and maintain the temperature. User can turn the controlling switch anticlockwise to a temperature lower than the current water temperature to turn OFF the fit for thermostat, and the heating-up indicator turns off. There is no separate heat controller for user. P.S:Please refer to the instruction manual for specific installation procedures,thank you !! Note: Do not allow any electrical appliances (such as lights, telephone, hair dryer, radio or television) in the bathtub, 1.5 meters (5 feet) or less. The fit for thermostat should not be used in salt water, acidic water or alkaline water, can not be used in other places chemically corrosive gases or solvents. Fit for Thermostat outlet to the bath tub in the middle of the pipe or valve or check valve can not be install. Package Content 1 x Water Heating Thermostat 2 x Interface 1 x Manual

Price: 293.74 USD

Location: Denver, Colorado

End Time: 2024-08-10T09:42:01.000Z

Shipping Cost: 0 USD